RickB
Yoda
Offline
I pulled the old seats this afternoon.
The backs of both are in pretty good shape.
The bottoms of both are about 80% there. the back edges of both pans are pretty much gone.
The rest of the pans are in salvageable condition, so how important is the back edge of the bottoms?
Oh yeah - any semblence of "clips" rusted away a long time ago.
Is there something that can be used instead, something I might be able to buy at my local True Value store?
I figure I can clean up what I've got then spray with that anti rust stuff that turns black.
The pivot points are still there on both seats, so I guess I need to replace that hardware as it's rusty but both sides still pivot forward / back.
The bottom frames are solid enough. I can wire brush & paint them.
Thoughts? Especially about the pans please?
The backs of both are in pretty good shape.
The bottoms of both are about 80% there. the back edges of both pans are pretty much gone.
The rest of the pans are in salvageable condition, so how important is the back edge of the bottoms?
Oh yeah - any semblence of "clips" rusted away a long time ago.
Is there something that can be used instead, something I might be able to buy at my local True Value store?
I figure I can clean up what I've got then spray with that anti rust stuff that turns black.
The pivot points are still there on both seats, so I guess I need to replace that hardware as it's rusty but both sides still pivot forward / back.
The bottom frames are solid enough. I can wire brush & paint them.
Thoughts? Especially about the pans please?