petnatcar
Senior Member
Offline
I got tired of my foot flopping around in the footwell so I fabricated this support pedal.
Use .080" aluminum sheet stock to make the pedal and 1 or 2 self tapping screws to attach it to the kick panel.
You'll need to drill through the kick panel into the metal of the footwell side panel.
A good metal shop can make this in 30 minutes or less using the attached full size pattern. (Based on 8.5 x 11 paper)
Cut and stick 2 strips of 3M Non-Skid material on the surface of the pedal.
This mod will leave 1 or 2 holes in the kick panel but the support you derive when cornering should override that drawback.
Use .080" aluminum sheet stock to make the pedal and 1 or 2 self tapping screws to attach it to the kick panel.
You'll need to drill through the kick panel into the metal of the footwell side panel.
A good metal shop can make this in 30 minutes or less using the attached full size pattern. (Based on 8.5 x 11 paper)
Cut and stick 2 strips of 3M Non-Skid material on the surface of the pedal.
This mod will leave 1 or 2 holes in the kick panel but the support you derive when cornering should override that drawback.