Jim_Gruber
Yoda
Offline
Need a source or someones spare part to put Bugsy back together.
HELP !!! I was feeling so proud of myself on progress today in installing front suspension, steering column, and remembered I need to tighten rack clamps. Got the torque wrench out and got to 20 lbs on PS Rack Bracket when I heard a very loud SNAP and the steering rack mount aluminum bracket snapped in half. I was using the original bolt and it appears the bolt bottomed out and the mount simply snapped.
MOSS does not sell this part. Anyone got a spare or know of a source for this part.
Also, There is a backing plate that goes behind this bracket. AH Spares catalog says two brackets are required. When I pulled apart only one was installed. IIRC only 1 bracket is needed and it goes on the side opposite the rack. AH Spares does sell that bracket.
So either a source for new or anyone got a spare on a parts car from a BE, Mark II or III. My hope of getting to a 10/26 show in Tampa a are dependent on finding one of these Clamps for PS. Thanks Team.
HELP !!! I was feeling so proud of myself on progress today in installing front suspension, steering column, and remembered I need to tighten rack clamps. Got the torque wrench out and got to 20 lbs on PS Rack Bracket when I heard a very loud SNAP and the steering rack mount aluminum bracket snapped in half. I was using the original bolt and it appears the bolt bottomed out and the mount simply snapped.
MOSS does not sell this part. Anyone got a spare or know of a source for this part.
Also, There is a backing plate that goes behind this bracket. AH Spares catalog says two brackets are required. When I pulled apart only one was installed. IIRC only 1 bracket is needed and it goes on the side opposite the rack. AH Spares does sell that bracket.
So either a source for new or anyone got a spare on a parts car from a BE, Mark II or III. My hope of getting to a 10/26 show in Tampa a are dependent on finding one of these Clamps for PS. Thanks Team.