When I purchased by '62 BT7, the turn signals were not working. The problem was in the flasher relay which I replaced from Moss. Thinking I would upgrade to LED lights at some point, I also installed a Moss electronic flasher unit. My BT7 has a three pin device with one pin driving the indicator lamp on the dash. I still have the original incandescent lights installed. My problem is that occasionally after I use the turn signal and then cancel it, the dash indicator light continues to faintly blink. I suspect a possible high resistance short in the turn signal switch. I have no ambition to pull that apart after reading about the fun other forum members have had with that assembly. Has anyone else had this problem and found a fix?
Doug
Gabriola Island, BC
Doug
Gabriola Island, BC