AUSMHLY
Obi Wan
Offline
64BJ8 II. Hi everyone.
I need some advise as to what I should do about installing the door seals. I'm attaching a photo of the passenger side, rear wing. You'll see I have a lot of things going against me. The body shop screwed the aluminum finish plate too low and you can see one of the rivets they used to rivet the wing to the car. (Even though I gave them the correct nuts and bolts to use) That rivet may get cover with the piping, if I'm lucky.
The area in question is the top, where it shows the blue metal under the aluminum finisher, which does not seem to be high enough and has sharp corners. (After market piece from Moss)
It is my understanding that the door seal will start on the top edge of the interior side panel, held in place with a clip. Continues across to the top, crosses over to the top of the aluminum trim panel. Continues down along the side edge of the door, along the bottom and up the front side of the door edge opening.
So what's up with that top corner on the rear wing? What do I do there?
What goes in between that one inch space on the top, between the wing and the interior panel?
Would someone attach a photo of what a finished one looks like, so I know what I need to modify.
Thank you, roger
I need some advise as to what I should do about installing the door seals. I'm attaching a photo of the passenger side, rear wing. You'll see I have a lot of things going against me. The body shop screwed the aluminum finish plate too low and you can see one of the rivets they used to rivet the wing to the car. (Even though I gave them the correct nuts and bolts to use) That rivet may get cover with the piping, if I'm lucky.
The area in question is the top, where it shows the blue metal under the aluminum finisher, which does not seem to be high enough and has sharp corners. (After market piece from Moss)
It is my understanding that the door seal will start on the top edge of the interior side panel, held in place with a clip. Continues across to the top, crosses over to the top of the aluminum trim panel. Continues down along the side edge of the door, along the bottom and up the front side of the door edge opening.
So what's up with that top corner on the rear wing? What do I do there?
What goes in between that one inch space on the top, between the wing and the interior panel?
Would someone attach a photo of what a finished one looks like, so I know what I need to modify.
Thank you, roger