I'm about to refinish my central gage panel and clean up the gages as a winter project. It looks, from what I can see on my back in the front seat, that there are just 2 wing nuts at the bottom holding the panel in. How is it held at the top? Is it really as simple as removing the two wing nuts and lifting the panel outwards?
The water gage had previously been replaced with an electrical, so no problem with fixed lines, other than the choke.
It was sure a lot easier working on these cars in the '60s when I was young, eager and flexable! The thrill of driving them doesn't change.
Thanks, Bob Burt
The water gage had previously been replaced with an electrical, so no problem with fixed lines, other than the choke.
It was sure a lot easier working on these cars in the '60s when I was young, eager and flexable! The thrill of driving them doesn't change.
Thanks, Bob Burt