jlaird
Great Pumpkin
Offline
Had one bolt hole from the rear of the tranny into the tranny main case that was striped out. Alum case.
Checked the hole deapth and found that the bottom 1/4 inch was not threaded. Cleaned it good all the way down.
Used a US thread bolt just the right length and turned it in with thumb pressure on the top and an open end wrench. It took just fine. All tight with a lock washer and such.
Where there is a will there is a way. PDO strikes again, oh wait it's me.
Checked the hole deapth and found that the bottom 1/4 inch was not threaded. Cleaned it good all the way down.
Used a US thread bolt just the right length and turned it in with thumb pressure on the top and an open end wrench. It took just fine. All tight with a lock washer and such.
Where there is a will there is a way. PDO strikes again, oh wait it's me.