Hopefully someone can help me. I am fitting a new soft top cover and tonneau to my BJ8 but have run into a few snags. My car does not have the two tennax pegs fitted to the rear shroud between the boot hinges. The hood cover I originally had was pop fastened round the rear. Does anyone have the dimensions for positioning the tennax pegs? and or a photo with dimensions.The fabric hood cover I have bought also has a strap attached to the interior side inner surface approximately opposite to the outer tennax peg on the chrome outer piece. Does this attach to the rear quarter pannel? and if so is it another tennax or a press stud?
With the tonneau cover, it obviously attaches to the lift the dot pegs on the dash and two tennax pegs behind the doors on the chrome finnisher and also to the two tennax pegs on the rear shroud.Are there any other fastenings? This probably sounds stupid but does it fit over the hood cover?Bizarrely although my car has none of the other fastenings it does have the lift the dot pegs for the tonneau behind the front seats.
Any help would be very gratefully received.
With the tonneau cover, it obviously attaches to the lift the dot pegs on the dash and two tennax pegs behind the doors on the chrome finnisher and also to the two tennax pegs on the rear shroud.Are there any other fastenings? This probably sounds stupid but does it fit over the hood cover?Bizarrely although my car has none of the other fastenings it does have the lift the dot pegs for the tonneau behind the front seats.
Any help would be very gratefully received.