Offline
Hi all,
As I embark upon my reassembly journal, I am putting together my doors while waiting for my mechanic to finish the engine rebuild and drop it into the chassis.
Everything went reasonably well, until putting in the window-glass. It rolls down smoothly for the first third, then it binds up. I can’t quite figure out why/where is is binding. Without the glass the regulator winds reasonably smoothly up and down.
Any thoughts? Did I mix up right/left window regulators? Is perhaps the tie rod installed incorrectly such that it is shifting the channels?
Thanks! I hope all are healthy.
Mike
As I embark upon my reassembly journal, I am putting together my doors while waiting for my mechanic to finish the engine rebuild and drop it into the chassis.
Everything went reasonably well, until putting in the window-glass. It rolls down smoothly for the first third, then it binds up. I can’t quite figure out why/where is is binding. Without the glass the regulator winds reasonably smoothly up and down.
Any thoughts? Did I mix up right/left window regulators? Is perhaps the tie rod installed incorrectly such that it is shifting the channels?
Thanks! I hope all are healthy.
Mike