I am nearing the end of a total rebuild of my 1967 87mm bore engine. The vehicle will be used for street use but I intend on milling/plaining the head to end up with a 10.1 CR and complement it with headers. The power valves will remain standard except for exhaust valve seat inserts and the pistons and liners are new Moss parts. THe car came with some extras which includes a pair of Weber 40mm sidedrafts, I do plan on using them but may start the engine with the standard carbs so I am not throwing in too many varialbles at the beginning. I would greatly appreciate your recommendations on cam selection, specs, manufacture or supplier and possible regrind company as well. I will tolerate a bit of a rough idle but am interested in drivability more then high RPM performance. If I should hold back a bit on the CR, I am open to your recommendations as well. I do have a good standard cam to go back with if necessary.
Thanks, Stan
1967 TR4A hardtail
Purchased summer of 2012, haven't heard it run yet.
Thanks, Stan
1967 TR4A hardtail
Purchased summer of 2012, haven't heard it run yet.