Pardon - I'm learning here - this is my first post other than an intro!
I rebuilt the driver's seat about 4 yrs ago with foam/parts from Moss. The project's been idle until the last two months but I don't remember any problems with the first seat. I installed the seat diaphragm on the 2nd seat. All clips installed successfully but I went out this morning and there was a failure on 3 of the locations that pulled the small rod through the rubber. The garage and parts were not cold (Don't judge... I live in Texas and the garage was about 68F.) I ordered a single replacement diaphragm but after searching the forums and not finding any with this specific failure, I'm wondering if this is an installation issue (it's me, not you...) or a defective diaphragm. Any thoughts?
I rebuilt the driver's seat about 4 yrs ago with foam/parts from Moss. The project's been idle until the last two months but I don't remember any problems with the first seat. I installed the seat diaphragm on the 2nd seat. All clips installed successfully but I went out this morning and there was a failure on 3 of the locations that pulled the small rod through the rubber. The garage and parts were not cold (Don't judge... I live in Texas and the garage was about 68F.) I ordered a single replacement diaphragm but after searching the forums and not finding any with this specific failure, I'm wondering if this is an installation issue (it's me, not you...) or a defective diaphragm. Any thoughts?