ekamm
Jedi Warrior
Offline
I purchased a fixed 5/8" reamer to ream my new lower wishbone bushing that fits over the trunnion, but after reaming one of them the hole was not well centered. The upper or first side that I passed through was fine but the lower or second side that the reamer passed through was off center. When inserting the trunnion there was an obviously uneven gap where the arm met the trunnion.
Does anyone have a good way for me to prevent this from happening and getting the hole reamed in the center of the arm? I used a drill press with a vise to hold the piece but couldn't figure out how to ensure that the bushing was in line with the reamer.
Does anyone have a good way for me to prevent this from happening and getting the hole reamed in the center of the arm? I used a drill press with a vise to hold the piece but couldn't figure out how to ensure that the bushing was in line with the reamer.