replacement horn relay

[skagroovy]

I tracked down my faulty horn to the relay after carefully taking it apart it was apparentlybeyond repair, so I got online and started searching... Stock replacement was over $75 at some outlets and as high as 99 for a relay
So i searched elsewhere since my tr6 is a daily drive not a show car.
Found a perfect match at auto zone. Part number 84601 or RL44 $6.99
Works great and mounts in original position.

Just a FYI...

 

[Gliderman8]

Glad you got it resolved :thumbsup:

 

[skagroovy]

Hmmm now the blinkers stoped working.... What did I touch.... Oh well...

 

[hondo402000]

check your fuses

Hondo

 

[skagroovy]

Fuses are good i was installing a new speedo cable and i think i was must have pulled something or bumped something coming out of the steering column...?

 

[skagroovy]

ok when i installed my new hazard switch toggle style in the middle of the dash replaced with an original the hazards work great but thats when the turn stitches stopped working any ideas

 

[Brosky]

<div class="ubbcode-block"><div class="ubbcode-header">Quote:]Hmmm now the blinkers stopped working.... What did I touch.... Oh well...[/QUOTE]

This sounds suspiciously like me putting lights on my Christmas tree.

 

[Mickey Richaud]

<div class="ubbcode-block"><div class="ubbcode-header">Quote:]Hmmm now the blinkers stopped working.... What did I touch.... Oh well...

This sounds suspiciously like me putting lights on my Christmas tree. [/QUOTE]

:lol: 'Tis the season!

 

[hondo402000]

we have the same year car, rock the hazard switch back and forth, when the its in hazard mode the turn signals will not work, suppose to stop current from going back thru the harness if the ign is off , When you turn the hazards off sometimes the contact is not made and the turn signals wont work. I had a problem with mine doing the same thing when I put my new harness in. And until i purchased a new 200.00 hazard switch I couldnt get them to work reliably.

the 70-71 switch is different from 72 on and the circuit is different

Hondo

 

[hondo402000]

Or you could have pulled the green wire off the voltage stabilizer

Hondo