Hey there Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
This is repost, I didn't get a chance to read replies before it vanished.
Hi
I would appreciate any help/opinions on a few of interior questions I have for TS9751L TR3.
I ordered an interior kit from Rimmer Bros, only ready made kit I could find that had the shade of blue I was looking for. The interior panels for the
rear quarter were vinyl covered millboard. Not only poorly covered but corners bent and pretty flimsy. Question #1- Would it be better to manufacture
them out of 1/8" plywood and recover?
The "fuzzy" draft seals for the doors. Question #2- Were they indeed the fuzzy material or covered with vinyl for the early model? I have seen pictures
both ways for newer vehicles.
Lastly, the footwell panels need to be replaced. The old ones rotted and had speaker holes cut into them. Question #3- 1/8" plywood for the material?
and the panels that were removed from car didn't fully back the carpet panel, just bottom 2/3 with large hole for dimmer switch on drivers side , top
arch was backed by millboard, should panel fully back carpet piece?
Any help appreciated.
Mary
Hi
I would appreciate any help/opinions on a few of interior questions I have for TS9751L TR3.
I ordered an interior kit from Rimmer Bros, only ready made kit I could find that had the shade of blue I was looking for. The interior panels for the
rear quarter were vinyl covered millboard. Not only poorly covered but corners bent and pretty flimsy. Question #1- Would it be better to manufacture
them out of 1/8" plywood and recover?
The "fuzzy" draft seals for the doors. Question #2- Were they indeed the fuzzy material or covered with vinyl for the early model? I have seen pictures
both ways for newer vehicles.
Lastly, the footwell panels need to be replaced. The old ones rotted and had speaker holes cut into them. Question #3- 1/8" plywood for the material?
and the panels that were removed from car didn't fully back the carpet panel, just bottom 2/3 with large hole for dimmer switch on drivers side , top
arch was backed by millboard, should panel fully back carpet piece?
Any help appreciated.
Mary
A friendly reminder - be careful what links you click on here. If a link is posted by someone you don't know, or the URL looks fishy, DON'T CLICK. Spammers sometimes post links that lead to sites that can infect your computer, so be mindful what you click.