Today I finally took the TR6 out for a test drive after rebuilding the engine (with a lot of help from the forum.)
The oil pressure was about 65-70 psi at idle in the shop. It came up to about 80 while driving. (2200-2500 rpm)about 6 miles up the road I noticed the oil pressure was droping.
It came down to 55-60 psi. I turned around and brought the car home. The pressure was then 45-50psi at idle.
I did not change the oil pump on the rebuild. Maybe should have.
I am sure that the slot on the dist fit properly on the oil pump dog. It slid in place with no pressure.
Any ideas?
The oil pressure was about 65-70 psi at idle in the shop. It came up to about 80 while driving. (2200-2500 rpm)about 6 miles up the road I noticed the oil pressure was droping.
It came down to 55-60 psi. I turned around and brought the car home. The pressure was then 45-50psi at idle.
I did not change the oil pump on the rebuild. Maybe should have.
I am sure that the slot on the dist fit properly on the oil pump dog. It slid in place with no pressure.
Any ideas?