Offline
I would like to get some guidelines as to where the panel screws should be located. I have checked my archive of pix and they seem to be all over. Can someone provide anything definitive? I will show a few from my collection of pix I have accumulated - some look good, some look just wrong, and no two look the same... Thanks in advance,
Pic 1 Comment/Question: too few along the curved front section? (should have 4, not 2?)
Pic 2 Comment/Question: one too few across top?
Pic 3 Comment/Question: 1 more than the number of holes along bottom compared to mine, otherwise looks good?
Pic 4 Comment/Question: an older piece but too few along curved front section?
Pic 6 Comment/Question: strange spacing along top but may be a different series - TR2 or TR3 vs TR3a or something?
Pic 7 Comment/Question: Too many along top?
Pic 1 Comment/Question: too few along the curved front section? (should have 4, not 2?)
Pic 2 Comment/Question: one too few across top?
Pic 3 Comment/Question: 1 more than the number of holes along bottom compared to mine, otherwise looks good?
Pic 4 Comment/Question: an older piece but too few along curved front section?
Pic 6 Comment/Question: strange spacing along top but may be a different series - TR2 or TR3 vs TR3a or something?
Pic 7 Comment/Question: Too many along top?
Last edited: