bcbennett
Senior Member
Offline
Hi all,
Just replaced my '74 TR6 heater unit with one that is rebuilt and ready. The previous owner had all the leads from the switch disconnected, and now, when I try connecting various combinations of the three wires (one hot, one low-speed, one high-speed), my fuse keeps blowing. I see two side-by-side connectors above the two vertical connectors, and I assume the hot wire goes to one of the upper prongs. Am I right? Help!
CB
Just replaced my '74 TR6 heater unit with one that is rebuilt and ready. The previous owner had all the leads from the switch disconnected, and now, when I try connecting various combinations of the three wires (one hot, one low-speed, one high-speed), my fuse keeps blowing. I see two side-by-side connectors above the two vertical connectors, and I assume the hot wire goes to one of the upper prongs. Am I right? Help!
CB