Offline
Just got my new weatherstrip material. It's rubber extrusion, with a slight "dusty" feel. Rub your finger on it and you pick up a dark gray smudge.
Loctite black weatherstrip adhesive instructions:
1. Clean surfaces thoroughly. Use abrasives to remove any powdery mold release from new weather-stripping.
2. Apply a thin, even film to both surfaces. Allow to dry.
3. Apply a second thin coat of adhesive to sections of weather-stripping not over 3 feet long.
4. Bond immediately.
Two questions:
1. how the heck do you "use abrasives to remove any powdery mold release ..."?
2. what is "apply a second thing coat to sections not over 3 feet long"? That implies you only put "fresh" adhesive on short sections. The first coat was allowed to dry.
Help!
Tom
PS - I called Loctite USA customer assistance. Spent 30 minutes on hold. I finally got a service rep. First thing he said was "Are you in Canada?" I said no. He said "Then you have to call our industrial division. Let me give you their phone number." good grief.
Loctite black weatherstrip adhesive instructions:
1. Clean surfaces thoroughly. Use abrasives to remove any powdery mold release from new weather-stripping.
2. Apply a thin, even film to both surfaces. Allow to dry.
3. Apply a second thin coat of adhesive to sections of weather-stripping not over 3 feet long.
4. Bond immediately.
Two questions:
1. how the heck do you "use abrasives to remove any powdery mold release ..."?
2. what is "apply a second thing coat to sections not over 3 feet long"? That implies you only put "fresh" adhesive on short sections. The first coat was allowed to dry.
Help!
Tom
PS - I called Loctite USA customer assistance. Spent 30 minutes on hold. I finally got a service rep. First thing he said was "Are you in Canada?" I said no. He said "Then you have to call our industrial division. Let me give you their phone number." good grief.