Hey there Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I am refering to shaft that lis located on firewall and retained in a bearing on each side and is used to connect gas pedal to carbs.
What is the easiest way to remove this from the firewall. It appears that this can be removed either by removing the two mill pins on the left or the mills pin on the right. Any suggestions on how to remve this assembly? Is the removal of the pins the only way to remove this assembly? My intent is to remove the plastic bearings on the shaft prior to having the tub tipped.
What is the easiest way to remove this from the firewall. It appears that this can be removed either by removing the two mill pins on the left or the mills pin on the right. Any suggestions on how to remve this assembly? Is the removal of the pins the only way to remove this assembly? My intent is to remove the plastic bearings on the shaft prior to having the tub tipped.
A friendly reminder - be careful what links you click on here. If a link is posted by someone you don't know, or the URL looks fishy, DON'T CLICK. Spammers sometimes post links that lead to sites that can infect your computer, so be mindful what you click.