I pulled my rear bumper last night. Hopefully, I get the tail light assemblies off tonight, so I can pull the rear wings on friday.
Anyway, when I took the bumper off, I noticed that the passenger side had caged nuts on the side and rear mounting points.
But the driver's side was held on with a traditional nut and bolt set.
Is this right or did a PO replace part of it?
Anyway, when I took the bumper off, I noticed that the passenger side had caged nuts on the side and rear mounting points.
But the driver's side was held on with a traditional nut and bolt set.
Is this right or did a PO replace part of it?