TR4/4A Part needed

[bertl]

I'm going with Herman's HVDA kit to install my W58 tranny in my TR3A. His kit requires the use of the TR6 pressure plate. Rather than have my TR3 flywheel redrilled/tapped for the smaller TR6 mtg pattern I'd prefer to go with a TR4A flywheel which uses the TR6 pressure plate. Anyone have one that they'd part with?

thanks for help

 

[JerryVV]

I might, I'll look. It would be a bit rusty but servicable. You may need to change starters too, I'm not sure about that, better check that issue too.

 

[bertl]

Jerry-
Near as I can tell the starters for TR3A (TS50001) thru TR4A are the same. Mine is TS51901 and uses the later version starter. The flywheels were the same ( except for bolt on ring gear vs pressed on) TR2 thru TR4 but used a larger pressure plate (10 7/8" mtg hold dia). The TR4A thru TR6 went to a smaller pressure plate. I'm not sure whether the TR6 crank bolt pattern is different or not. If yours is a TR4A, it should be bolt on ring gear, and be 11" overall diameter (not including the ring gear) and the mtg hole diameter for the pressure plate should be 9 7/8".

If you have one please PM me with cost and possibly pictures of both sides.
I appreciate your offer,
Bert