-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
T-Series 5 Speed Transmission
- Thread starter PAUL161
- Start date
Share this page
OP
Offline
I was surprised that with the crossbar cut out the tranny setting on a transmission jack slides right into place without any problems. the two bell housing guide pins were a little tight but all went well. 
The U joint on the new driveshaft rear flange is meatier and won't allow the original bolts to go in, so I'll have to take a couple of threads off the ends to shorten them so they will drop in. Less than 1/4 inch back and forth Freeplay on the shaft once mounted. Getting there. 
The U joint on the new driveshaft rear flange is meatier and won't allow the original bolts to go in, so I'll have to take a couple of threads off the ends to shorten them so they will drop in. Less than 1/4 inch back and forth Freeplay on the shaft once mounted. Getting there. 
Online
Sounds like you’re making good progress.
Offline
While your at it put a hose clip on the column excluder.
OP
Offline
Good idea! Thanks.
