Happy New Year to all!
I am in the process of installing door panels and have been disapponited by the very small trim screws purchased from TRF or Moss (don't remember which). They are so small it is difficult to get them in perfectly straight and flat. AND when not flat they tend to dig into the vinly. Has anyone opted to go a little bigger?
I think the look of the door-panel install would be a nicer finish with perhaps twice the head are for the cup washer and or screw.
If anyone has gone larger please advise on where to locate the large chrome screws and cup washers. I have found larger locally but all are phillips-head
regards,
Griff
I am in the process of installing door panels and have been disapponited by the very small trim screws purchased from TRF or Moss (don't remember which). They are so small it is difficult to get them in perfectly straight and flat. AND when not flat they tend to dig into the vinly. Has anyone opted to go a little bigger?
I think the look of the door-panel install would be a nicer finish with perhaps twice the head are for the cup washer and or screw.
If anyone has gone larger please advise on where to locate the large chrome screws and cup washers. I have found larger locally but all are phillips-head
regards,
Griff