• The Roadster Factory Recovery Fund - Friends, as you may have heard, The Roadster Factory, a respected British Car Parts business in PA, suffered a total loss in a fire on Christmas Day. Read about it, discuss or ask questions >> HERE. The Triumph Register of America is sponsoring a fund raiser to help TRF get back on their feet. If you can help, vist >> their GoFundMe page.
  • Hey there Guest!
    If you enjoy BCF and find our forum a useful resource, if you appreciate not having ads pop up all over the place and you want to ensure we can stay online - Please consider supporting with an "optional" low-cost annual subscription.
    **Upgrade Now**
    (PS: Subscribers don't see this UGLY banner)
Tips
Tips

TR2/3/3A Speedy Sleeve Repair Sleeves for Rear Axle Pinion and Half Shafts

Share this page

M

mastaphixa

Jedi Trainee
Bronze
Country flag
Offline
I'm looking for the part number for the speedy sleeves for the rear axle pinion and half shafts. I've seen the sleeves referenced here but not the part numbers.
Thank you,
Steve Baker
 
T

TR-3rg

Jedi Hopeful
Country flag
Offline
Hi,

Moss shows a listing for the pinion. I replaced my pinion seal and inner axles seal on my 1960 TR-3a. The inner seals were leather, I assume original. They just polish the surface, and did not dig a groove in it. I had the speedy sleeves for it, but I did not have anything to slide over the axle to install them.

Good Luck.

Roy
 
Similar threads
Thread starter Title Forum Replies Date
prb51 TR2/3/3A TR3 Dif Pinion seal and speedy sleeve Triumph 12
S TR2/3/3A Speedy sleeves Triumph 6
Barryp Rear hub seal speedy sleeves? Austin Healey 2
Hap Waldrop Acme Speed Shop just got a bit more speedy Spridgets 13
Joel Lester TR2/3/3A What size speedi-sleeve needed for pinion seal on a TR3? Triumph 6
Lin Thermostat and blanking Sleeve question again Austin Healey 7
K TR2/3/3A TR3 Tie Rod Sleeve Triumph 2
K Wanted TR3 Tie Rod Sleeve Triumph Classifieds 2
Michael Oritt Speedi-sleeve p/n needed Austin Healey 7
Healey Nut Thermostat blanking sleeve Austin Healey 13
RAC68 Radiator Core Replacement and Sleeve Thermostat Alternatives Austin Healey 20
Jim_Gruber Hubs a Rocking on side where Speedi Sleeve was installed Spridgets 5
R TR6 bronze sleeve for release bearing Triumph 1
M TR2/3/3A Sleeve and Piston Sizes Triumph 6
Jim_Gruber Speedi Sleeve Install and New Diff Gasket Spridgets 5
Jim_Gruber Speedi Sleeve required for this application - Need advise! Spridgets 12
T TR4/4A Release Bearing Sleeve Triumph 0
Michael Oritt Speedi-sleeve part number Spridgets 0
K TR2/3/3A Clutch and Gearbox Sleeve Differences. Triumph 12
M TR2/3/3A TR3 overdrive trans rear speedi sleeve Triumph 6
BoyRacer Top bows - plastic sleeve for socket Austin Healey 0
K TR2/3/3A When assembling a release bearing to the sleeve? Triumph 4
R TR2/3/3A Steering, stator tube compression sleeve? Triumph 4
K TR2/3/3A What's the easiest way to remove the clutch release bearing from the bronze sleeve? Triumph 7
B TR2/3/3A TR3 Cylinder Sleeve Installation Triumph 10
T SKF Speedi-sleeve p/n for tailend of transmission? Triumph 3
B inner bushing sleeve on pin? Triumph 5
K TR4/4A Paging TR4nut re Timken speedi sleeve? Triumph 4
K TR2/3/3A Tr3:installing a speedi sleeve timing chain cover? Triumph 4
B TR6 TR6 Front Oil Seal Sleeve Triumph 3
M Speedi sleeve question Triumph 7
PatGalvin TR2/3/3A Wet Sleeve to Engine Block Deck Clearance, TR3A Triumph 4
mgnewbie Speedi-sleeve for the gearbox rear oil seal MG 7
W Suggestions on wiring sleeve Spridgets 3
lorendad Speedi-sleeve Triumph 10
M Cylinder sleeve protrusion Triumph 4
T Apple Hydraulics for M/C re-sleeve Triumph 11
Ohiobugeye Bugeye Fuel Line Nut & Sleeve For Gas Tank Spridgets 12
I TR6 TR6 Trunion installation/stop sleeve help Triumph 4
dklawson Spitfire Spitfire - Trunion Bushing/Sleeve Clearance? Triumph 2
KVH Revelation Re Those Figure 8 Sleeve Gaskets Triumph 8
Basil Redi-Sleeve for Spitfire? Spridgets 6
ronzet MGA MGA 1500 Thermostat Blanking Sleeve MG 22
budk1953 Speedi-sleeve Spridgets 11
W TR6 TR6 Crank oil seal sleeve Triumph 4
P thermostat/blanking sleeve? MG 5
MGTF1250Dave Speedi-sleeve for Timing Cover Seal Triumph 15
G Oil Seal Sleeve......This is getting to be a pain Triumph 0
Steve P. master brake/clutch re-sleeve...suggestions Spridgets 3
K TR2/3/3A Update on the head gasket repair......something is not right/ Triumph 5

Similar threads

Top