See email below. This is a reply from pertronix tech support about setting the spark plug gap when having a pertronix ignition.... Can anybody comment on if this is good or see any improvement or other issues when increasing the gap as mentioned below by pertronix?
"
From: Marvin [tech@pertronix.com]
Sent: Thursday, April 17, 2008 8:13 AM
To: jason
Subject: RE: Product Support Question/Issue
Jason,
We suggest opening the gap between .005-.007 over the stock settings.
Marvin
-----Original Message-----
From: PerTronix Product Support [mailto:info@pertronix.com]
Sent: Wednesday, April 16, 2008 7:53 PM
To: tech@pertronix.com
Subject: Product Support Question/Issue
Apr 16, 2008
********** COMMENTS **********
I bought a Lucas 25d distributor with pertronix electronic iginition in it.
I also bout a pertronix flamethrower 3.0 ohm coil to go with it in my 1500 mg midget.
When going to electronic ignition, should I have a larger gap for my spark plugs? If so what should I set the gap to?
Jason
"
"
From: Marvin [tech@pertronix.com]
Sent: Thursday, April 17, 2008 8:13 AM
To: jason
Subject: RE: Product Support Question/Issue
Jason,
We suggest opening the gap between .005-.007 over the stock settings.
Marvin
-----Original Message-----
From: PerTronix Product Support [mailto:info@pertronix.com]
Sent: Wednesday, April 16, 2008 7:53 PM
To: tech@pertronix.com
Subject: Product Support Question/Issue
Apr 16, 2008
********** COMMENTS **********
I bought a Lucas 25d distributor with pertronix electronic iginition in it.
I also bout a pertronix flamethrower 3.0 ohm coil to go with it in my 1500 mg midget.
When going to electronic ignition, should I have a larger gap for my spark plugs? If so what should I set the gap to?
Jason
"