• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Rotary Sprite

Share this page

Going to be interesting to see how the bonnet clears.
 
Jim_Gruber said:
Going to be interesting to see how the bonnet clears.
Click to expand...
Well I actually got the hood on tonight, I had to drop the RAD another 5* and offset it to the passenger side a few inches to get the Rad cap to clear. I may have to go to a pancake fan as well, but will try and shoehorn the existing HD in fan first as it provides more CFM's than the pancake. I'll post a pic of the final stack up once I complete piping it all up.
 
Ok here's the rad with the hood on, it was as difficult as I thought but she in there with room to spare! Here the Rad, covered for protection from weld spatter with the hood up!
 

Attachments

  • 20886.jpg
    20886.jpg
    79.7 KB · Views: 478
Here's the hood closed!
 

Attachments

  • 20887.jpg
    20887.jpg
    74.4 KB · Views: 495
Here's a shot of where the 3500CFM 12" pusher E-fan will go!
 

Attachments

  • 20888.jpg
    20888.jpg
    69.5 KB · Views: 477
That looks great. I found in converting to a BE Bonnet on my '68 just how tight all of the underhood clearances actually are. Makes you understand why the went away from BE Bonnet, wasn't only for styling.
 
No, no wait, sorry...there isn't room for the duct hose to the heater. Take it all out and do it again. :jester:
 
Thanks all,and yeah I'm going to miss that big close dryer hose. I should be getting the drive-shaft back this week, and then all I will need is a battery, some cables, add fluids, and I should be able to get it fired up.
 
Here's the final cool'n set-up!
 

Attachments

  • 20954.jpg
    20954.jpg
    83.1 KB · Views: 433
Another view!
 

Attachments

  • 20955.jpg
    20955.jpg
    83.2 KB · Views: 521
Cheese
 

Attachments

  • 21009.jpg
    21009.jpg
    79.8 KB · Views: 481
Baby Blue Eyes - nice
 
It is so neat that folks have the skills to do this.
 
jlaird said:
It is so neat that folks have the skills to do this.
Click to expand...
Thanks, but I got to thank my Daddy for the skills, this man worked us like mules when we were young, there was nothing he would not make us do.
 
JPSmit said:
Baby Blue Eyes - nice
Click to expand...
Thanks, halogens too so there functional as well as pretty!
 
Drive shaft is done, come to find out a ford ranger rear yoke and flange fits right up to the stock diff flange. It's a go for start this weekend!
 
What is the diameter and spline count for the output shaft of the Mazda transmission. I am working on a T5 conversion for my car, and I am wondering if a shortened Ranger drive shaft might work.
 
I'll try and get that info tomorrow!
 
Back
Top