I wrestled the original OEM TR8 starter out of my '80 TR8 project and have a Rover-spec replacement (like BP Northwest has listed at https://www.bpnorthwest.com/triumph...l/starter-gear-reduction-new-rover-v-164.html.) The original starter has a unique setup for connections: battery connection post, another large terminal post, plus two wires that screw in together on another connection and then a lone small wire that screws into the other side.
So the question is: how do I wire this all to a new starter and solenoid that has the same two large posts on the solenoid plus one spade connector post?
Any ideas would be great, because I can't find a single place on the web that indicates how to wire all these individual wires to the starter/solenoid.
So the question is: how do I wire this all to a new starter and solenoid that has the same two large posts on the solenoid plus one spade connector post?
Any ideas would be great, because I can't find a single place on the web that indicates how to wire all these individual wires to the starter/solenoid.