dklawson
Yoda
Offline
I cannot remember which forum on this board where the topic was discussed but somewhere I remember a discussion about what to apply to the face of Smiths gauges after cleaning to prevent the white lettering from continuing to flake off.
I seem to remember that someone on the board suggested using something like hair spray. Does anyone remember what was suggested or have other suggestions for a protective coating that would restore that nice satin finish without causing the lettering to be damaged?
Thanks in advance for your suggestions.
I seem to remember that someone on the board suggested using something like hair spray. Does anyone remember what was suggested or have other suggestions for a protective coating that would restore that nice satin finish without causing the lettering to be damaged?
Thanks in advance for your suggestions.