• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A Tr-2 Clutch Problem

Share this page

I can confirm you don't have to remove the TOB pin bolt to remove the TOB, the last time I refitted the gearbox during the maneuvering to get it lined up the TOB fell off which was a bit frustrating.

Graham
 
Redoakboo said:
I will follow your recommendation on bleeding the MC before I install. I think that pin is O.K. I can move the lever forward and back with my hand, easily. If when everything is set up again, and it won't go into gear, I will be forced to remove the b#&)n% transmission.
Click to expand...
When you say it wont go into gear is that with the engine running or not running?
Have you had the engine and transmission separated and the clutch off the flywheel since you got the car? The reason I ask is the friction disk can bond to the flywheel if it has not moved for years. I had an engine and transmission that had sat for some years and found the friction disk had to be pried off the flywheel.
With the clutch depressed I could not get it into gear.

David
 
Back
Top