• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Strange fastener advice

Share this page

jcatnite

jcatnite

Jedi Knight
Offline
I broke the (for lack of a better term) pedestal bolt that holds the intake and exhaust manifold on my 1500 tonight. I knew it was toast as soon as I put the wrench on it. It seems to be a stud that has a spacer welded in the middle. Moss and VB don't show a replacement. Any other 1500 owners ran into this? I might just turn a nut down to the proper thickness and use a new stud. Also, I broke the EGR valve off the exhaust manifold. Of course the pipe is still in the manifold. I thought about trying to drill it carefully and then pick the remainder out of the thread. I had been using heating and PB blaster treatment on it for about a week before I got the courage to put a pipe wrench on it. Does anyone know if I can weld that port up? I got the feeling that the exhaust manifold is cast and I've never had much luck welding that. Just canvasing for suggestions.
JC
 
[ QUOTE ]
pedestal bolt that holds the intake and exhaust manifold

[/ QUOTE ]

Are you talking about one that goes into the head?

That Zenith Stromberg manifold is cast - find a professional welder who does that type work
 
No the bolt I'm talking about screws into the intake manifold just below the carb flange. It's hard to describe. I think I can make one. I could get similar results by welding two bolts together head to head. The only thing is I'm not sure a weld like that would hold up to the vibration and I don't know if I could find two bolts that had heads thin enough. I'm sure this sounds confusing...lol.
JC
 
Cast can be welded just fine.
 
JC, unless you are going for originality, I think you can live without that bolt. I run headers on my car, and there is nothing connecting the header to the intake. I have had no problems (with that part of the car anyway).
 
Back
Top