gregsdrums
Senior Member
Offline
Has any one ever removed the ignition key/lock switch on a 79 midget? Suggestions would be greatly appreciated.
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Removing ignition key/lock switch?
- Thread starter gregsdrums
- Start date
Share this page
Offline
Once the cowl is off, there are a couple "breakaway" bolts you'll need to either drill and use an easy-out to un-do or a Dremel and thin cut-off wheel to slot 'em to allow using a screwdriver for the task.
... and don't forget to disconnect the battery FIRST! :wink:
... and don't forget to disconnect the battery FIRST! :wink:
lbc_newbie
Jedi Warrior
Offline
Don't forget to remove or protect your dash....It's a messy, tedious job! I found it easier to use the dremmel and cut through the pot metal rather than cut through the screws. Not much room there if you don't remove your dash. Good luck!
OP
gregsdrums
Senior Member
Offline
Thanks guys. Ever so grateful...
lbc_newbie
Jedi Warrior
Offline
G
Guest
Guest
Guest
Offline
I always used an old screwdriver or a small chisel to unscrew those. Catch it on the outter edge as well a s you can and tap to unscrew. The driver or chisel will dig in and turn the screw. Best to give it a wack straigh on to give you a grove to start in first. That way it won't try to slide off when you hit.