-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Rear Lever Arm ? 65
- Thread starter HAN8L1965
- Start date
Share this page
bugimike
Yoda
Offline
blkcorvair
Jedi Knight
Offline
yep you could surely use one of them tie rod seperators, looks like a fork thats wedge shaped.
64rocksprite
Jedi Trainee
Offline
Timely subject - I just took mine apart today! I separated them while the shocks were still on the car though.
I placed a good sized screwdriver between the lever arm and the "joint"..then (with nut on) whacked the stud with a BFH..came loose on the third swing. Keeping it under tension was the trick at least in my case..
I used the same BFH prior to using the screwdriver for tension..and it would not budge.
Give it a shot if you don't have a tie rod separator.
I placed a good sized screwdriver between the lever arm and the "joint"..then (with nut on) whacked the stud with a BFH..came loose on the third swing. Keeping it under tension was the trick at least in my case..
I used the same BFH prior to using the screwdriver for tension..and it would not budge.
Give it a shot if you don't have a tie rod separator.