-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Help with Diff
- Thread starter tomgt6
- Start date
Share this page
V
vagt6
Guest
Guest
Offline
This heavily depends on how you're gonna drive the car. Do you like hole shots? Are you looking for more "oomph" from dead starts? Do you drive agresively? Then go for the 4.11.
But for driveability, I vote for the 3.89. A 4.11 is a very geary ratio IMHO. With the 3.89 your revs should be somewhere in the high 3000s at about 60, and give you all the grunt you need around town.
The 4.11 makes any kind of highway speeds VERY revvy.
To each his own, but for casual, around town driving and occasional highway jaunts, I'd go with the 3.89.
But for driveability, I vote for the 3.89. A 4.11 is a very geary ratio IMHO. With the 3.89 your revs should be somewhere in the high 3000s at about 60, and give you all the grunt you need around town.
The 4.11 makes any kind of highway speeds VERY revvy.
To each his own, but for casual, around town driving and occasional highway jaunts, I'd go with the 3.89.
Offline
At 60 mph, the difference between a 4.11 (3820 RPM) and a 3.89 (3600 RPM) isn't very much. One other factor to consider is that a 3.89:1 diff complete will require you to change the u-joint flanges on your propeller shaft and axle shafts to the larger size, and you'll only have four studs to hold down your leaf spring (not really a problem). If you get a 4.11 diff (or already have one), odds are it's the older style with the smaller flanges as original on your Spitfire. Otherwise, either will bolt right up to the chassis.
Remember, the Mk3 Spitfire came with the "small journal" 1300 and a 4.11 diff, while the early MkIV had the "large journal" (and single Stromberg) 1300 and a 3.89 diff (ignoring, for the moment, the 1972 "Federal" Spitfire with its low compression 1300 engine and a reversion to a 4.11 ratio but in the newer case with larger flanges).
There's a chart on my web site showing various gearbox and differential ratios for most of the Triumph "small car" lines.
Remember, the Mk3 Spitfire came with the "small journal" 1300 and a 4.11 diff, while the early MkIV had the "large journal" (and single Stromberg) 1300 and a 3.89 diff (ignoring, for the moment, the 1972 "Federal" Spitfire with its low compression 1300 engine and a reversion to a 4.11 ratio but in the newer case with larger flanges).
There's a chart on my web site showing various gearbox and differential ratios for most of the Triumph "small car" lines.