• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Fuel Sending Unit

Share this page

TulsaFred

TulsaFred

Jedi Warrior
Country flag
Offline
I cleaned up my old Bugeye sending unit, getting ready to install it in a new field tank.

I'm assuming this is an original Smiths unit. Don't know if it works or not.

How can I test it while on the bench?

Fred

2i8b3ic.jpg

2n0d2t.jpg

ddjnut.jpg
 
I would think that just connecting a VOM meter to check its resistance as you move it slowly through its range would do it. Visually it looks pretty good. I think that the major problems with them is the lever not making contact or the resistance coil having a break in it. May also have some continuity issues at the terminal end's.

Kurt.
 
0 Omhs at one end and 80 Ohms at the other.IIRC.
 
I always connect a ground wire from the case to one of the bolts holding the gas tank. This assures a good ground.
Scott in CA.
Looks like an original unit.....some of the aftermarket ones are junk!
The aftermarket units have a very coarsely wound coil.
 
Thanks, I'll put an ohm meter across it and move the float and see what I get.
A ground wire sounds like a good idea, too.
 
Back
Top