• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Front suspension is out!

Share this page

Thanks for the instructions (and the picture especially!). I think at least I now understand how the axle hub works, so I should be in better shape to get it off. Jeff is loaning me his hub puller, so I should be ready to go with the removal.

I like the brake drum concept, too. Seems pretty clever to me. That 1/8" flat stock goes between the flipped drum and the hub, correct?
 
yup
 
I was actually looking for a hub puller myself as I'll need to pull the backing plate from my rear brakes to replace the adjuster, does anyone know what size I'll need for a 67 sprite? I see up to 5 inch or 6/7/8 inch.. The car is out of state, so I can't measure, and would like to have the puller waiting for me next time I head up to work on her.

-Daniel
 
I suppose if you are careful you could use the reverse drum trick without damaging the drum.
 
I think you'll find as I have, that the reversed drum and a large mallet will remove the hub. Turn and pound on the drum. You wont hurt it.
 
A slide hammer works in a pinch....

opposite studs with a nut and a 3/8" i.d. washer on backwards.

Plan "B" is a plug ....stepped so as to fit in the axle tube and center drilled for the puller point. Two jaw puller that can get behind a 5" diameter hub.

Center nut torqued to about 80' # on reassembly.
 
Morris
Jedi Knight


Registered: 08/31/05
Posts: 809
Loc: Austin, TX Jerry B,

I tried to PM you about spring pans, but it says your mailbox is full???
_________________________

M.....

I just p.m.'ed you......you can reply by e-mail which is easier for me.....
 
Re: Front suspension is out!SAVE MORE JUNK !!!!

Bugeye58 said:
Drew, do you have the socket to remove the hub nuts? It takes a 1 7/8" socket.
Jeff
Click to expand...

Is that standard on all sprites or just the BE? I've got a MarkIV (67) would it be the same?
 
That's how I got the drum off in the first place, a few well placed wacks with a rubber mallet /bcforum/images/%%GRAEMLIN_URL%%/grin.gif
 
""""Is that standard on all sprites or just the BE? I've got a MarkIV (67) would it be the same? """"""

all Spridget housing hub nuts are the same size.
One is LH (on the left) and the other is RH thread.
 
Back
Top