• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Front hub puller?

Share this page

drooartz

drooartz

Moderator
Staff member
Gold
Offline
What sort of hub puller do I need for the front hubs? I'm in the process of disassembling my disc fronts, and need to get them apart so I can send the A-frames/kingpins out for rebuilding.
 
Drew, No hub puller needed. If you have wire wheel hubs there is a grease cap that can stump you briefly, but otherwise, undo the split pin, undo the nut, and pull. It will come off disturbingly easy.

Peter C.
 
These are disc wheels. So I can just pull the hub off the stub axle? Geesh...
 
Not much force at all. One of mine needed very little persuasion with a 3 armed puller, the other one came right off.
 
I'll give it a go tonight. I'll admit, I never even tried to pull them off, figured the tool was necessary.

Well, that's what the manual said! /bcforum/images/%%GRAEMLIN_URL%%/grin.gif
 
PeterC said:
Drew, No hub puller needed. If you have wire wheel hubs there is a grease cap that can stump you briefly, but otherwise, undo the split pin, undo the nut, and pull. It will come off disturbingly easy.

Peter C.
Click to expand...

Don't forget about the tabbed washer behind the nut. If you don't remove that first, it can make things a little more difficult.
 
Sure enough, couple good pulls and everything came off. Just need to get the bearings out, and all will be well. A-frames and kingpin are ready to be sent out for work now.
 
Drew, you rolling right along.
 
Back
Top