• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Failed State inspection-tie rod end..follow up

Share this page

J

jbuffalo

Senior Member
Offline
I had the shop put in a new steering rack assembly and new tie rods (inner) as they were worn out. Now the steering is tight and harder to turn. Is this something that will break in or is there an adjustment? thanks Jim
 
My first thought is that the shop might not have re-installed the shim in the correct place to align the rack with the steering column. Check for the shim on the left side of the rack where it bolts to the cross-rail. If there is no shim, NOT GOOD.

Glen Byrns
 
Which way did they install them? Up or down?
 
With the front of the car up in the air and the front suspension loaded (block or jackstand under the outer part of each lower a-arm) you should be able to turn the front wheels lock to lock with ONE finger.

If harder , then return to the "shop" tht did the install and have them correct.

Chances are the rack was not installed with the correct radial clocking in relation the the steering wheel shaft.
 
Or the vertical spindles are too snug, sigh.
 
Back
Top