• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR6 Bolt size/thread count for fuel sender TR4/TR6

Share this page

T

tdskip

Yoda
Offline
Well so much for the idea that I was diligent on packing and labeling everything.

Anyone know off hand the thread size/count for the thread that are used to secure the fuel sender to the tank by chance?

Moss #323-370 or #28 in the schematic below.

TRI-012.gif


Thanks!
 
I have em out in the garage in a bag if you need em!
 
Stanpart TR6504, which is 10-32 by 1/2" long.
 
10/32's X 3/8s oval head straight tip.
Copper washer?
 
Yep... I concure... 10/32's is it!
 
DNK said:
no, each of them little screws has a fiber washer
Click to expand...
Only fiber washers on mine are where the bolt/stud for the wire passes through the plate. The bolts that hold the sender to the tank only have internal star lock washers (P/N WN0705) per the SPC.
 
all of mine has a small which I thought copper washer. The diagram Tom posted list a fiber washer
 
In the immortal words of Emily Litella:
 

Attachments

  • 21556.jpg
    21556.jpg
    23.9 KB · Views: 907
Apparently TR4-6 did have fiber washers, TR2-3 had lock washers.

My bad.
 
Back
Top