The dash cover has been a huge struggle to get it to fit well. I am not sure if the more expensive offering from Moss would have been easier but the cheaper one has been a task.
Getting the old bulb holders out of the dash was a tricky and I did find the star washers are available on the Moss site under the MGB section.
I did manage to get 1 star washer off with the pick method but the others seem to have bitten into the bulb holders so I could not get them to move. Was more worried about the bulb holders than the star washers.
I managed to get the cover glued down and the edges glued in place. The cut outs for the gauges and switches do not match very well. If I had to do it again I would clean All the residual foam off the switch and gauge area as that was partly responsible for preventing the switches locking into the dash. There were 2 switched that I could not get to lock in and I noticed that the old switch had a wire spring clip. Used a dab of hot melt in desperation.
I tested the Tachometer using my TR3A as a tester. It works so the only gauge I have not tested is the fuel gauge. All the others work.
The finished look.
David