The temp gauge only barely moves when operating under normal conditions.
Today I rigged up a way to check it against a known temperature. With the water boiling the gauge only went about half way over.
I checked across the sending unit at normal (4K ohms) and with water boiling (260K ohms). Does anyone know what these values should be.
i would like to determine if the problem is with the gauge or the sending unit. I think the voltage stabilizer is ok as the fuel gauge seems pretty accurate.
Appreciate any suggestions or ideas.
Today I rigged up a way to check it against a known temperature. With the water boiling the gauge only went about half way over.
I checked across the sending unit at normal (4K ohms) and with water boiling (260K ohms). Does anyone know what these values should be.
i would like to determine if the problem is with the gauge or the sending unit. I think the voltage stabilizer is ok as the fuel gauge seems pretty accurate.
Appreciate any suggestions or ideas.