Leo_Speichinger
Senior Member
Offline
I am running out of ideas on a possible solution sooo... I have a Crane XR 700 electronic ignition and the stock electrical tach. The tach worked fine until I installed a new dash at which time I had to remove everything to install the dash. Now when i start the car the tach needle goes to 1500 rpms and stays there. No meeter movement off of 1500 until I shut the engine off. Have double and triple checked all the wiring and everything seems to be fine unless I am missing something. Anybody have any ideas of what might be the problem?
Thanks
Leo
Thanks
Leo