• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

xpag oil pump

Share this page

T

tmp

Freshman Member
Country flag
Offline
hello, could some one tell me how to remove the driven gear shaft from the xpag block? thank you. sincerely, tom
 
Tom, I sent you and E-mail and will try and get my books back. Maybe someone else can help before then. Wayne
 
Aloha TMP,

I've never done this, but my workshop manual for TD and TF describes the procedure. After having removed the oil pump cover, withdrawing the driven gear, removing the pump from the block along with the drive gear and shaft, "Screw a suitabale extractor into the end of the driven gear shaft and withdraw it from the cylinder block if it is required to remove this." Probably easier said than done, however it sounds as if the bore of the shaft maybe threaded. With the engine in the car, I imagine there isn't alot of room to work. Good luck.

Safety Fast,
Dave
 
Back
Top