• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR4/4A Wiring the horn when installing a Moto -Lita steering wheel

Share this page

E

eyesie

Guest
Guest
Offline
I am sure this has been asked before, but here goes. I am planning to install a moto-lita steering wheel on my TR4, and was wondering how to make the horn connection? Any photos would be great.
On another note, in the past I bought a banjo style wheel off Ebay. I was told it was for a TR4. I just found out the ID of the boss is less the slip ring, so obviously not for a 4. Any ideas as to what this could be off? It is 16" Dia. See photos
 

Attachments

  • IMG_3643.jpg
    IMG_3643.jpg
    51.5 KB · Views: 186
  • IMG_3645.jpg
    IMG_3645.jpg
    41.8 KB · Views: 160
Do you have a picture of the boss you will use to mount the Mota Lita wheel? Some bosses use the same style brush as the original wheel, others may have a spring loaded connection built in to contact the horn ring.
 
Yes, this one has the spring loaded connection , with a spade connection on the back. After speaking with my son, I understand that I connect this spade directly into the harnes connections, the ground is through the boss.
 
Back
Top