Jimflorida
Jedi Trainee
Offline
I'm looking at (1) my Bugeye windshield frame and (2) the windshield I just cracked trying to install it. The windshield frame was originally made in two pieces, the upper curved piece and the lower straight rail, and you can see where these were welded together at the two bottom corners with a mitre joint. Wouldn't it be a heck of a lot easier to just go about an inch above that mitre joint, make a straight cut on both sides of the frame to separate the bottom piece, install the windshield and gasket, put the bottom piece back on and just weld back up the aluminum cut. It would be easy and a lot cheaper than cracking another windshield. Jim