-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR2/3/3A Windshield Aftermarket
- Thread starter z3m
- Start date
Share this page
TRopic6
Jedi Warrior
Offline
In case anybody's curious, I came across 2 bolts I got from a parts car (TS3100L) around 1990. They were in the aeroscreen mounting holes, chrome with chrome washer. Did the factory put them in all cars with mounting plates just to fill the holes?
It has fine threads same as the 1/2" bolt for the hardtop, shown for comparison. However, the head on the aeroscreen mount is smaller, fitting a 7/16" wrench. Total length is 1.15". Top part .275"; .2" hex with a .075 'dome'. The washer is 5/8" across and .075" thick with a slight bevel on the outer edge about .070 wide.
It has fine threads same as the 1/2" bolt for the hardtop, shown for comparison. However, the head on the aeroscreen mount is smaller, fitting a 7/16" wrench. Total length is 1.15". Top part .275"; .2" hex with a .075 'dome'. The washer is 5/8" across and .075" thick with a slight bevel on the outer edge about .070 wide.
