-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A Windshield Aftermarket
- Thread starter z3m
- Start date
Share this page
TRopic6
Jedi Warrior
Offline
In case anybody's curious, I came across 2 bolts I got from a parts car (TS3100L) around 1990. They were in the aeroscreen mounting holes, chrome with chrome washer. Did the factory put them in all cars with mounting plates just to fill the holes?
It has fine threads same as the 1/2" bolt for the hardtop, shown for comparison. However, the head on the aeroscreen mount is smaller, fitting a 7/16" wrench. Total length is 1.15". Top part .275"; .2" hex with a .075 'dome'. The washer is 5/8" across and .075" thick with a slight bevel on the outer edge about .070 wide.
It has fine threads same as the 1/2" bolt for the hardtop, shown for comparison. However, the head on the aeroscreen mount is smaller, fitting a 7/16" wrench. Total length is 1.15". Top part .275"; .2" hex with a .075 'dome'. The washer is 5/8" across and .075" thick with a slight bevel on the outer edge about .070 wide.
