• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

What is this thing !?!?!?!?!?!?

Share this page

G

Guest

Guest
Guest
Offline
I've got a '79 Midget and it has a cable that runs from the bellhousing to the crossmemeber? What is it for and how tight should it be? Thanks.
 
ahh yes, I remember that thingy, it is some kind of a torsion stabilizer. I took mine offof my '75, but I would torque it based on the diameter of the rod.
 
It's part of the safety system. There to keep the engine in the car in event of a collision I believe. Tighten it enough so that the engine can't pull entirely out of its mounts and you should be fine.
 
Think I'll pull it off. If involved in a accident, motor-in-car is the least of my worries. I'm getting a weird, cyclic osilation vibration which seems to be at engine speed through the car. Similar to a dry bad u joint or motor mount. I'll pull it off as it seems to help transfer this vibration to the car.
 
On a Morris Minor, there is a steel cable tying the trans to the chassis AND a steel rod tying the head to the firewall (with the classically British name "anti-judder support". Apparently Morris designers were very concerned about the engine/trans/staying put or excessive "juddering". I never put any of that back on. But if my car suddenly starts "juddering", I'll think about it.

Glen
 
Back
Top