• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A What is the carb setup on this TR3A?

Share this page

rlwhitetr3b

rlwhitetr3b

Jedi Knight
Offline
It looks like an aftermarket manifold that uses two two-barrel carburetors.

Has anyone seen these before?

This is the ebaymotors item number: 190352534713
Look in the "additional photos" section.
 
Those are Webers.
Or, old Pinto Ford carbs.

Don't know if I like that.
Down draft, side draft, updraft, angle draft.....see the adaptor from the head to the cast mount?

Doesn't look too hot on the front of #1 runner.
 
Part number: 487930
Weber Carburettors

32/36 DGV type with manual choke. Complete kit comprising linkage, air filters and special adaptors to suit the Weber base flange. We just launched a superb Weber carburettor upgrade kit for the legendary Triumph TR6. The real beauty of this kits is that it retain the standard intake manifold and combine a healthy power increase along with excellent fuel economy
TR250, TR6 carburettor models


https://www.scparts.co.uk/index/lan...75/functiontpl-virtueller_katalog.tpl,x-a.htm
 
I could not remember where I had seen that carb before. I had a Vega back when they were new and it had a weber simular to that on it.

I looks like the site you linked to wants about $1250 USD for the setup.
 
And it specifies for a 6-cylinder engine....

I really don't like the external looks of the flow pattern.
Probably bench flow tested just fine, but downdraft into a puddle...across, up, then angled down into the heads.

Sure looks like it would be hard to keep the fuel in suspension.

The side-draft versions look like a much better flow path.
 
Looks like the bonnet and trunk lid are mismatched for that car. I don't see the raised plinths for the hinges.
 
Back
Top