Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Hi, another question about putting my '76 B back together(problem is I didn't take it apart) I think this will be easy but I haven't been able to ID this part in any of the order books or in photos. On the rear deck before the trunk lid, there is a large threaded hole on both sides about 1/4" or so, what goes in there and what is it called? One more, on iether side just rear of the door latch there are four holes in a square and then a single hole to the rear of the four, same question as above.Thanks for the help on the window, and any help with this one would be great!Thanks, John
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
what goes here?
- Thread starter JMACK
- Start date
Share this page
Offline
I think that the two holes on the rear deck lid are for the chromed items that anchor the rear of the hood (roof). There is a flat metal bar that goes across the back of the soft top, and this locates into the two holders on the rear deck. I think that it is referred to as a retainer, #49 as in this Moss Motors drawing.
https://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=29087
https://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=29087
Could be for the bar but on my 69 there are two small holes to hold each of the 2 bar fittings and are just good sized posi or phillips screws from inside trunk. If the holes are closer to the rear of the cockpit they may (depending on the year of car) be for the bolts holding the seat belts. There were large chromed bolts with a rubber tab that fit there. Some company in Canada (Mackintosh??) sells little rubber plugs to plug the holes. I just put the original chrome bolts back in to fill the holes.
also...the 4 holes (kind of on top, correct) are for steel part that holds the edge of the top. They are pop riveted in, if I remember correctly. The one behind it...I am not sure (there is nothing in the one on mine as I had the same issue not having been the one to take all the stuff off) is likely for a snap base or stud (snap I believe) for the tonneau. Would like to see the responses as I have never had a tonneau and wasn't really sure.
G
Guest
Guest
Guest
Offline
The two large holes on the top rear deck on my car have plastic plugs in them and I don't use them for anything. The bolts that fasten the seat belts in fit those holes so it may have been an alternate point for a shoulder strap. I lost one of my plugs for a short time and couldn't find any mention of them anywhere in any catalog. They aren't for the hard top as mine fastens to the chrome hooks the soft top hooks to.
The four holes if I picture what you said correctly, are for the plastic holder designed to hold the end of your seatbelt when you are parked. The other hole further back is for a snap but at the moment I cant remember what it is for. I think it is for part of the toneau cover that covers the top when it is down.
Bob
[ 02-24-2004: Message edited by: mrbassman ]</p>
The four holes if I picture what you said correctly, are for the plastic holder designed to hold the end of your seatbelt when you are parked. The other hole further back is for a snap but at the moment I cant remember what it is for. I think it is for part of the toneau cover that covers the top when it is down.
Bob
[ 02-24-2004: Message edited by: mrbassman ]</p>
I was wondering about the rear deck holes myself (my 69 has bolts in them). I bought two 3 point seat belt harnesses from Wesco in CA and used the bolts to anchor the shoulder strap. I used the old lap buckle at that location so I could clear the way for the top when stowing it, then reconnect it. You might want to try that.
tony barnhill
Great Pumpkin - R.I.P
Offline
2 large holes on rear deck were for seatbelts...there was a period of time when they were located up there....as for the 4 holes on the side, if they're where I think they are, they're what holds the top bows to the body....could you post pics so we can see better what you're talking aobut?