Vacuum Line on a 948

[mxp01]

All:

I have a 948 engine with the H1 carbs. There is a hard vacuum advance line that runs from the distributor to the base of the carb. It has a small ferrule fitting at the carb connection. Does anyone know the size of that ferrule fitting?

Thanks,

MXP

 

[Joe Schlosser]

I thought it was the opposite. Threaded end on distributor and rubber connection to carbs. My H1 carbs are in a box somewhere so cannot be sure

 

[Desert Rat]

Threaded at the front carb and distributor. MXP are you looking for thread size or wrench size? I have an original out in the garage I can dig out.

 

[mxp01]

I'm looking for the thread size. I need a new compression fitting.

Thanks,

MXP

 

[Desert Rat]

Gotcha. I’ll be able to measure it tomorrow.

I'm looking for the thread size. I need a new compression fitting.

Thanks,

MXP